FMUSER Wirless Transmit Video And Audio More Easier !

[email protected] WhatsApp +8618078869184
Language

    FM transmitter Making Experiment

     

    This is a relatively simple practical production, this paper intends to in-depth step by step from simple to complex, if you are willing to experiment hands simultaneously, and soon you will be able to make suitable for formal occasions, the use of FM transmitters. Of course, the experiment is to start from the most simple, below is a simple oscillator, which is the basis for the FM transmitter.

    FM调频发射制作实验

    Figure in the coil of enameled wire in 3.2mm with 1.0mm drill around 6-8 on the circle, can cover 88-108MHz, 7 lap around at 100MHz. Click the image to connect, in fact, is a simple transmitter, the power to launch, but the launch is not amplitude modulated signal, a nearby FM radio receiver to the signal will only be muted. Like the following figure, as with modulated signals, can enter into the functional state.

    FM调频发射制作实验

    Then, if you Walkman, DVD players and other audio signal connected to the output of the transmitter audio input graph, in the vicinity can use to listen to the radio. Although the figure can be fired, but not practical, one is the emission energy is very small, only for indoor use, but also in outdoor open to tens of meters. The second is the frequency of instability, because the antenna is a wire, through 100P capacitor connected with the oscillation circuit, so the antenna will affect the environment around the transmitting frequency. If you want to reach the level can be combined with the subsequent polarization of amplification, as shown below.

    FM调频发射制作实验

    This should be a friends request Dachu amplifier circuit, the output power is satisfactory, but there are many problems, will be detailed below. Oscillator and amplifier together, it becomes a complete FM transmitter, as shown below.FM调频发射制作实验

     

     

     

     

    The transmitter is easy to chart the success of production, referred to here is the success of the antenna power supply can be plugged into the working state, if want to work into the best state of the transmitter need to do some debugging. In fact, the fans do the experiment greatest pleasure is to make debugging work through their own hands to perfect, the best performance.
    First, the output circuit in non-Group A state, the load impedance has more stringent requirements, usually more than the transmitter output to 50Ω, 50Ω enthusiasts experiments are not necessarily easy to find the RF cable, RF cable 75Ω everywhere buy Moreover 75Ω antenna is easy to make, therefore machine 75Ω output, the output power should be preceded by a 75Ω termination resistor, 75Ω followed after the completion of commissioning of the antenna. 1W maximum output over the machine, do not use the kind of small 1/8W resistors, connected to the fire. Burn down a little resistance, but resistance of an amplifier is equivalent to burning load, the tube in danger.
    After the commissioning of the power needed to launch the main contents of the tube is operating point, the working point of the harmonic components of different output significantly different. The local oscillation level selection transistor operating point to a larger dynamic, the measured second harmonic Bobijibo low over twenty db, four times lower, completely negligible. A near-level work to promote the B class status, it does not produce large energy harmonics. Lies in the output stage. Output stage operating point of choice is too much trouble, under the bias on the bias resistor and 51Ω resistor divider formed should be lower than the emitter voltage of the launch tube to work in between B and C states. Close to B when used 1KΩ state, then launch tube current 260mA, output power 700mW, the second harmonic is about 10dB lower than the main wave, four times less energy in the frequency of the output 500mW or more.
    With the bias resistor on the increase, the working status of the launch tube near the C class, power meter's instructions but added increases, the maximum up to 1300mW, but this time all of this harmonic is gradually strengthened, but the main wave power reduced. In the professional manufacture, is not difficult to resolve this contradiction, but the circuit is designed for beginners made simple type, had to give up power efficiency indicators, the proposed use on the bias resistor 1KΩ. Experiment 2SC2053 severe fever, although the experiment did not damage, estimated long-term use will not do, it is recommended for use when making two 2SC2053 2SC1970 or parallel. Parallel to the attention of current measures are taken. If you just want a taste of hands-on production of fun, does not necessarily require such a large output power, how far does not need to launch, then you can make s
    FM调频发射制作实验
    ome changes to the circuit parameters, the circuit structure unchanged, with the 6V power supply, the output power In more than 100mW, shown below.
    And on the same circuit structure diagram, just change a few component values​​, transistor also made adjustments. Since the output power less to do with the 3355 output tube output do not consider the security problem, you can work long-term stability.

     

     

     

     

    List all Question

    Nickname

    Email

    Questions

    Our other product:

    Professional FM Radio Station Equipment Package

     



     

    Hotel IPTV Solution

     


      Enter email  to get a surprise

      fmuser.org

      es.fmuser.org
      it.fmuser.org
      fr.fmuser.org
      de.fmuser.org
      af.fmuser.org ->Afrikaans
      sq.fmuser.org ->Albanian
      ar.fmuser.org ->Arabic
      hy.fmuser.org ->Armenian
      az.fmuser.org ->Azerbaijani
      eu.fmuser.org ->Basque
      be.fmuser.org ->Belarusian
      bg.fmuser.org ->Bulgarian
      ca.fmuser.org ->Catalan
      zh-CN.fmuser.org ->Chinese (Simplified)
      zh-TW.fmuser.org ->Chinese (Traditional)
      hr.fmuser.org ->Croatian
      cs.fmuser.org ->Czech
      da.fmuser.org ->Danish
      nl.fmuser.org ->Dutch
      et.fmuser.org ->Estonian
      tl.fmuser.org ->Filipino
      fi.fmuser.org ->Finnish
      fr.fmuser.org ->French
      gl.fmuser.org ->Galician
      ka.fmuser.org ->Georgian
      de.fmuser.org ->German
      el.fmuser.org ->Greek
      ht.fmuser.org ->Haitian Creole
      iw.fmuser.org ->Hebrew
      hi.fmuser.org ->Hindi
      hu.fmuser.org ->Hungarian
      is.fmuser.org ->Icelandic
      id.fmuser.org ->Indonesian
      ga.fmuser.org ->Irish
      it.fmuser.org ->Italian
      ja.fmuser.org ->Japanese
      ko.fmuser.org ->Korean
      lv.fmuser.org ->Latvian
      lt.fmuser.org ->Lithuanian
      mk.fmuser.org ->Macedonian
      ms.fmuser.org ->Malay
      mt.fmuser.org ->Maltese
      no.fmuser.org ->Norwegian
      fa.fmuser.org ->Persian
      pl.fmuser.org ->Polish
      pt.fmuser.org ->Portuguese
      ro.fmuser.org ->Romanian
      ru.fmuser.org ->Russian
      sr.fmuser.org ->Serbian
      sk.fmuser.org ->Slovak
      sl.fmuser.org ->Slovenian
      es.fmuser.org ->Spanish
      sw.fmuser.org ->Swahili
      sv.fmuser.org ->Swedish
      th.fmuser.org ->Thai
      tr.fmuser.org ->Turkish
      uk.fmuser.org ->Ukrainian
      ur.fmuser.org ->Urdu
      vi.fmuser.org ->Vietnamese
      cy.fmuser.org ->Welsh
      yi.fmuser.org ->Yiddish

       
  •  

    FMUSER Wirless Transmit Video And Audio More Easier !

  • Contact

    Address:
    No.305 Room HuiLan Building No.273 Huanpu Road Guangzhou China 510620

    E-mail:
    [email protected]

    Tel / WhatApps:
    +8618078869184

  • Categories

  • Newsletter

    FIRST OR FULL NAME

    E-mail

  • paypal solution  Western UnionBank OF China
    E-mail:[email protected]   WhatsApp:+8618078869184   Skype:sky198710021 Chat with me
    Copyright 2006-2020 Powered By www.fmuser.org

    Contact Us